Best well and pump technicians near Hendricks, MN

If you have a self-cleaning washing machine but you’re still seeing lint, your water pump filter might be clogged. To clean it, you should unscrew the drain hose, then remove the water pump filter. From there, you can inspect it and clean it with warm water before replacing it. Check to be sure your washing machine is functioning by running a short cycle. 

No. Well pump replacement is not recommended as a DIY project, particularly if you have a deep well and a submersible pump. Plumbing and electricity are best left to the pros, especially when something like your well pump includes both. Even when troubleshooting your pump, it pays to have a partner standing by for your assistance and safety.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

You should have your well inspected once per year. You should also have a well inspection done when you’re buying a house with a private well, when the well cap is opened, when the septic tank is repaired, or when there is flooding.

During your annual visit, a pro will make sure that everything is working correctly and check for certain contaminants, including total coliform. Every other year, they’ll look for things like metals and nitrates, and every five years, they’ll test for pesticides.