Top-rated stucco pros.

Best stucco pros near Benson, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Benson, MN?

Select your specific project to find the pro for you.

Top-Rated Stucco pros in Benson - Updated Nov 2026

Stucco FAQs, answered by experts

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Hiring a professional for stucco repair ensures accurate diagnosis and application of appropriate techniques to prevent further damage. They deliver seamless results that maintain aesthetic appeal and prolong the exterior’s life.

Cracks in the chimney can be very serious, depending on their location and size. Even small cracks can become serious over time if left unrepaired. Cracks allow heat and moisture to deteriorate your chimney and harmful carbon monoxide gas to seep into your home. Small cracks can often be caulked, while large cracked sections may require full replacement.

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

The Benson, MN homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.