Top-rated ceiling fan pros.

Get matched with top ceiling fan pros in Patten, ME

Enter your zip and get matched with up to 5 pros

Need a pro for your ceiling fan service project in Patten, ME?

Select your specific project to find the pro for you.

Find Ceiling fan pros in Patten

Avatar for New England Home Renovations LLC
New England Home Renovations LLC
4.0(
311
)
Ceiling Fan - InstallCeiling Fan - Repair

Serving Patten, ME and surrounding areas

In business since 1983

Free estimates

Emergency services offered

"I had hired Richard's company to install a new fan in our bathroom.  They installed the fan but chipped the plaster around the edge of the fan and then left the plaster on the floor covering it with the bathmats.  I didn't intend to use NE Renovations again, but decided that all of the glowing recommendations from Angie's List must not be wrong.  I contacted Richard to install a new kitchen faucet the I had purchased. I told him about the plaster issue.  He came and installed my faucet when he said he would.  Several weeks later I emailed him to ask when he was going to send the invoice and he told me that he was not going to charge me because of the previous issue.  This kind of customer service is hard to find these days."
Before
After's
New boiler install
Removal of cast Iron to PVC.
Additional Photos

+37

Recommended by89%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Ceiling Fan - InstallCeiling Fan - Repair

Serving Patten, ME and surrounding areas

In business since 1971

Credit card accepted

"The furnace took 4 days to get approved( not counting a Sunday) the others were quick but the water heater had to be ordered so without hot water for a week. One ceiling fan was easy but within a year their policy changed and They would not install the one I purchased and had to get a new one approved and then ordered online and took several weeks to get straightened out. Not sure who was at fault, AHS, installer or scheduling with renter. Fee is usually $75 per visit"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Ceiling Fans questions, answered by experts

To determine if your ceiling box can support a fan, you must check if it is specifically fan-rated. Manufacturers are required to indicate this on the box itself. You may need to remove the existing light fixture to look inside the ceiling box for an inscription stating it is rated for fan use. If you do not see this confirmation, the box is likely not strong enough and must be replaced with a fan-rated junction box. For a proper and safe installation, you should also use a fan brace to secure the new box between the ceiling joists, which provides the necessary support for the fan's weight and motion.

There are several telltale signs to let you know that your ceiling fan needs servicing or replacement. For instance, if it’s wobbling, rotating too slowly, or if your ceiling fan is making noise such as squeaks, buzzes, and thumps, it’s time to have it looked at by a professional. Not only may it indicate a potential problem with the fan itself, but it could also signal a red flag that it’s improperly assembled or there’s an issue with the wiring.

Many ceiling fan-rated electrical boxes tend to be made of metal. However, some electrical boxes may also be made of heavy-duty plastic that is reinforced with metal support structures. It may also have an attachment that connects directly to a ceiling joist. If you are ever ensure, consult with a licensed professional to get their insight on best practices and whether the installation is a safe one.

The most efficient ceiling fan height is 8 to 9 feet from the floor to the fan blades. For ceilings higher than 9 feet, a downrod can be used to lower the fan to the optimal height. This positioning ensures adequate air circulation and maximizes the cooling effect. Remember, fans should be installed at least 7 feet above the floor for safety.

If you’re removing a ceiling fan without visible screws, start by locating the fan canopy—a round cover placed above the fan blades and motor. There should be a thin ring that can be turned counterclockwise to remove the canopy and reveal the screws. After unscrewing the fan, you can disconnect the wires and remove the entire fan from the mounting hardware. For safety, make sure the fan switch is turned off before you remove the canopy. It may be easier to remove the fan blades first, too.

The Patten, ME homeowners’ guide to ceiling fan services

From average costs to expert advice, get all the answers you need to get your job done.