Get matched with top handymen in Clinton, ME

While handypeople do not need to be licensed in many places, you should only hire insured pros for any home improvement work. Your handyperson should have active liability coverage that protects them and you in the case of an error or accident. Furthermore, if they have employees on your property, they should also have workers’ compensation insurance. If you hire an individual or a company that is not insured and they damage your property, have an accident while on the job, or become injured on your property without insurance, you can be held financially liable.

In most states, handypeople do not need to be licensed to perform simple home repair tasks and smaller jobs. When projects exceed specific cost amounts, however, ranging from $500 in California to $50,000 in other states, some municipalities consider them to be contractors, meaning they need to be licensed. To learn if your handyperson should be licensed to work on your job, contact your local governing body or state contractors’ licensing board before starting any work.

The cost to hire a handyman can vary, with most charging on a per-hour or per-project basis. On average, expect to pay between $50 and $150 per hour, with a typical rate around $90 per hour. For project-based work, the average cost is about $400, though the total can range from as low as $180 to $1,500 or more. Some handypeople may also require a minimum flat rate, such as payment for two hours of work.

Several factors influence the final cost, including:

• The type, size, difficulty, and complexity of the job

• The amount of time the work takes

• The handyman's experience level

• Your geographic location

• The cost of materials and any necessary permits

• Accessibility of the work area and potential travel costs

Additionally, you may encounter higher rates or extra fees for emergency services or work scheduled during holidays.

Yes, you can use a dremel tool to cut plexiglass. Follow the instructions under “How to Cut Plexiglass with a Saw,” and use a dremel tool with a 561 bit instead of a saw.