Get matched with top concrete driveway pros in Watson, LA

Does the water in your taps sometimes come out very slowly? If so, you might have problems with low water pressure in your house, and your pressure washer won’t effectively clean. To test if your water pressure is sufficient, time how long it takes for the water from your hose to fill a 5-gallon bucket. Usually, if it takes less than two minutes, you’re good to go.

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

Yes, a pressure washer uses less water than a garden hose. There are many ways to use a pressure washer, and it can be an eco-friendly hose substitute. While a pressure washer expels water with greater force, it uses 50% to 70% less water than a garden hose. Specifically, hoses put out six to 10 gallons per minute (GPM), while pressure washers only use two to five GPM.

Maintaining a driveway depends on its material. For concrete and asphalt, it's best to clean the surface thoroughly twice a year with a stiff broom and a pressure washer to remove accumulated dirt and debris. Sealing the driveway is crucial to protect it from water damage and freeze-thaw cycles. Before applying a sealant, pressure wash the surface to remove any loose sealant, dirt, or stains, as sealing over them will trap them. Any cracks or expansion joints should be filled with a flexible polyurethane caulk or asphalt sealer. In colder climates, use sand instead of salt for de-icing. Sand helps melt snow and ice without accelerating the freeze-thaw process, which can cause cracks.