Get matched with top stone and gravel pros in Plainville, KS

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

Limewash can be removed from brick, but the method of removal will depend on how long the limewash has been on the brick. If the limewash has fully dried—which happens after about five days—you’ll need to use a diluted muriatic acid mixture to remove it. If there are multiple coats of limewash, you may need to apply the acid mixture several times to fully remove it from the brick.

Chimney mortar typically lasts 20 to 30 years, depending on its quality, local weather conditions, and maintenance. Over time, exposure to moisture, freezing, and thawing cycles can cause mortar to deteriorate, leading to cracks and gaps. Regular inspections and timely repairs, such as repointing or tuckpointing, can extend the lifespan of chimney mortar by ensuring the structure's integrity.

You may not need a hammer drill if you’re planning on drilling one or two very small diameter holes in brick. For holes with a diameter of 3/16-inch or less, a regular drill with a masonry bit can do the job. However, the bit will heat up quickly, and the process will take significantly longer than with a hammer drill. Prepare to cool your drill bit down in a bucket of water more often.