Get matched with top mulch and topsoil pros in Smithville, GA

Hydroseeding is a great option for sloped yards, as sod might not root as well. Hydroseeding also traditionally creates sprouts faster than normal seeding—up to a full week faster. Additionally, you can customize your slurry mix with hydroseed, allowing you to create a mixture that will work specifically for your yard’s conditions. 

It’s important to remember that hydroseeded lawns require a lot of water during the first few weeks of installation, which can be time-consuming and costly. Additionally, the installation window tends to be shorter than that of sod and traditional grass. 

The right depth depends on your intended use for the area. For instance, pea gravel for walkways and patios typically only needs to be about 2 to 3 inches deep. However, driveways and other areas with heavier loads may require 4 to 6 inches for better stability.

You can use regular sand as the base for your pavers and in between pavers to seal the joints. Many pros reach for polymeric sand, also known as all-purpose sand, because it has been sifted and washed to remove impurities. But you can easily level ground and fill gaps between pavers for a clean look using regular sand, sometimes at a lower cost.

It depends on the model of your pool. You’ll always have to level the topsoil, but most vinyl-lined pools require an additional 1- to 2-inch layer of sand to protect the liner. This way, when a foot kicks down to the bottom of your pool, it’s not scraping the liner against the hard ground. If your pool isn’t vinyl-lined, you can skip this step or add a layer of another base material, like decomposed granite. Always check your manufacturer’s instructions before you begin.