Get matched with top buffing and polishing pros in Steamboat Springs, CO

Using water when cutting stone drastically reduces the amount of dust that comes off the stone. It’s beneficial to cut down on the amount of dust for respiratory and other safety reasons, such as keeping your vision clear while using an electric tool. Even with protective eyewear, the dust can still cloud your safety glasses. You should always wear protective gear when cutting stone.

Buffing is a less expensive and less time-consuming alternative to other floor repair techniques, but it’s only ideal for removing surface-level scratches and damages. Floor-buffing machines work to gently smooth out the floor’s top layer rather than removing it the way that sanding does. 

This process is ideal for gently worn floors, but it won’t have the desired impact on floors with severe damage. On the other hand, sanding fully strips the floor’s top layer so damages beneath the surface are accessible to remove or repair. Since the process is more involved, it requires more time, tools, and experience to achieve the best possible results.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

When cleaning your patio, you’ll need to ensure the chemicals you use aren’t harsh enough to destroy the seal or stones. You can clean the stones with a mixture of white vinegar and water or soapy water and a scrub brush. Just be sure not to use wire brushes, as these can scratch the surface.