How Much Does It Cost to Move Washer and Dryer Hookups in Minneapolis, MN? [2026 Data]

The cost to move washer and dryer hookups in Minneapolis, MN, averages $1,258, with most homeowners paying between $891 and $1,886. The final price depends on the distance between the new hookup location and existing utilities in your home, with higher costs if the new hookups are located on a separate floor or in an area without plumbing lines. Many homes in Minneapolis, MN, are older and also require plumbing retrofitting, electrical upgrades, and other work to bring the home up to code before relocating laundry hookups.

Washer and Dryer Hookup Relocation Cost Factors

The cost to move a washer and dryer hookup in Minneapolis, MN, depends on the existing plumbing, drain lines, electrical system, and gas connections.

Installing a Washing Machine Cut-Off Valve

A cut-off valve is necessary to stop the water supply to your washing machine. Your washing machine cut-off valve will likely cost $10 to $30 per line.

Building a Drain Line for the Washer

Relocating your washing machine gets trickier when plumbing costs are involved. And one major plumbing cost for relocating your washer and dryer is installing a drain line. Depending on how close it is to the existing plumbing, the price could range anywhere from $365 to $1,570.

If you try to tackle this work yourself and make a mistake, you’ll need to get a plumber in pronto. However, costs will be significantly higher. Emergency plumbing costs up to three times as much as standard plumbing.

Installing Electrical Outlets and Circuits

Your washer should run on a dedicated circuit with a standard 120V outlet, while dryers need a 240V circuit and outlet. The cost to install a new outlet and circuit is around $315 if you need one for the washer, and about $525 if you need a 240-volt circuit for the dryer.

Running a Gas Line

If you’re installing a gas dryer, you’ll need to factor in the cost of running gas lines to your new laundry room. Prices vary, but the cost for a new gas line typically falls between $125 and $1,415 or more, based on how far you run the lines. Expect to pay $15 to $24 per linear foot. You also may need to cap an existing gas line, which costs around $130.

Dryer Vent Installation

Dryers need a place to push out that hot air, so don’t forget to consider installing a dryer vent. A new dryer vent costs an average of $105 but can reach $1,055 depending on the length of the vent.

Repairing Drywall

After you finish installing new hookups, you’ll likely have some minor drywall repair needs. Minor drywall repair can cost as little as $105, and your plumber or electrician may even include it in their labor cost. Sometimes, when moving your washer and dryer, you’ll uncover mold or water damage that needs further attention. In these cases, it’s best to call a mold remediation pro to test and suggest the best course of action.

Installing New Machines

Once you’ve set up everything, you’ll have to think about installing or moving the washer and dryer. If you’re buying new units, many will include installation in the cost. If that’s not the case, you can find an appliance installation service near you and get it done for about $50 to $185 per unit.

Washer and Dryer Hookup Pro Costs

The cost to hire a local appliance pro in Minneapolis, MN, to move washer and dryer hookups depends on labor rates, permits, and other tradework required.

Labor

Local plumbers in Minneapolis, MN, usually charge either by time and materials or by a flat rate to move washer and dryer hookups. Plumbers charge $45 to $200 per hour, plus materials, with projects taking between six and 12 hours, depending on complexity. Moving washers and dryer hookups within the same room or to a wall with existing plumbing requires less time and materials, while relocating hookups to different rooms or floors can drive up total costs.

Permits

Moving washer and dryer hookups usually requires pulling plumbing and electrical permits from the City of Minneapolis Development Review division. Minimum fees for plumbing permits start at about $85, and electrical permits range from $35 to $315, depending on the work needed. Expect to pay higher fees if your contractor must complete extra work and obtain more permits to bring your home up to code, such as electrical panel upgrades, venting, gas line installations, structural modifications, or drainage work.

Additional Pros to Consider Hiring

Relocating laundry hookups may require work from additional pros, depending on code requirements or the total scope of your project. For example, a general contractor may be the right choice to oversee the plumber and other professionals if moving the hookups is part of a much larger renovation project. These are the professionals commonly involved:

• Electrician: $45–$95 per hour

• Dryer vent specialist: $115–$135 per hour

• Drywaller: $1.90–$2.50 per square foot

• General contractor: 10%–20% of total project cost

Does Relocating Washer and Dryer Hookups Increase Home Value?

Relocating washer and dryer hookups doesn’t have a direct impact on home value in Minneapolis, MN, but this project can yield a 40% to 60% return on investment (ROI) if it’s part of a larger laundry room remodel. Many older neighborhoods in Minneapolis, MN, have laundry machines in unfinished basements, but moving the units to a dedicated room in a more easily accessible area of the house can offer major appeal.

How Angi Gets Its Local Cost Data 

To help homeowners plan their next project, Angi provides readers with carefully researched cost data and upholds strict editorial standards. We start with national average project costs, which we collect by analyzing competitor information, retailer material costs, and input from professional contractors. We then apply local price index data to calculate location-specific estimates that reflect what homeowners typically pay in their local area. To do that, we use data from the U.S. Bureau of Economic Analysis (BEA), including its Regional Price Parities (RPPs), which measure price differences across cities. This helps us account for differences in labor, materials, and overall cost of living, so estimates in higher- or lower-cost areas better reflect real-world local pricing.

Every estimate undergoes a thorough editorial review to verify accuracy, consistency, and alignment with observed market conditions.

Want to help us improve our cost data? Send us a recent project quote to [email protected]. Quotes and personal information will not be shared publicly.