How Much Does Furnace Repair Cost in Detroit? [2025 Data]
Furnace repair costs in Detroit, MI, are $282 on average. The final cost depends on the furnace type, which part needs repair, and labor rates in your area, so the final price will range from $127 to $452. Reach out to a local HVAC pro for an accurate estimate.


The specific component that needs repair or replacement and the type of furnace you have are the most crucial cost factors to consider.
Most homes in Detroit use gas heat, and repairing a gas furnace is more expensive than repairing electric furnaces, the next most common type in the area.
The cost of living in Detroit is just slightly under the national average, which means lower labor costs and below-average prices.
Consider signing up for ongoing preventative maintenance to help your furnace run efficiently through the long, cold winters in Michigan.
Furnace repair costs in Detroit average $282, and most homeowners pay somewhere between $127 and $452. The type of repair you need and the type of furnace you have will impact your costs the most. Since the winters are so harsh in Detroit, furnace breakdowns can become emergencies, so you may need to budget two to three times the standard cost for the rush service.
Furnace Repair Cost Factors
For minor furnace issues in Detroit, MI, you could pay as little as $75, but prices can climb as high as $900 if you need a major repair, like replacing the blower motor or heat exchanger. You’ll need to consider all of the following factors to get an accurate estimate for your project.
Repair Cost by Part
Regardless of their fuel source, furnaces are complex appliances that have a lot of moving parts. Some of those parts significantly influence furnace repair costs, while others are simpler and less costly to repair.
Here is the average furnace repair cost based on the part:
Furnace Part | Average Cost |
---|---|
Burners | $135–$400 |
Blower motor | $135–$1,800 |
Circuit board | $180–$540 |
Coils | $530–$1,800 |
Combustion chambers | $90–$540 |
Draft inducer motor | $180–$1,400 |
Flame sensor | $135–$220 |
Flue pipe | $360–$720 |
Furnace filter | $50–$150 |
Gas valve | $180–$540 |
Heat exchanger | $90–$1,400 |
Ignitor | $130–$450 |
Relay switch | $130–$270 |
Thermostat | $90–$540 |
Transformer | $90–$160 |
Nearly 75% of all homes in Michigan use natural gas for home heating. Some of the more expensive repairs are only applicable for gas heat, like those for burners, combustion chambers, and ignitors, so repairs will tend to be more costly. Around 10% of homes in the state use electric furnaces, and your repair costs will be lower if you have an electric furnace.
Maintenance Cost

A furnace requires regular maintenance in order to operate efficiently. Otherwise, dust and other debris can clog burners, the pilot light, and other parts, causing more wear and tear on the system. Additionally, furnaces see a lot of wear and tear in cold climates like the one in Detroit. Your furnace will need to contend with long, frigid winters and work overtime to keep your home warm, safe, and comfortable. It’s always a good idea to carry out routine furnace maintenance, but it’s especially important in areas like Detroit.
As such, you should consider the cost of inspections and ongoing maintenance for your furnace. A furnace inspection costs $80 to $100 on average, and you need to schedule an inspection at least once per year to keep your system running smoothly. An advanced inspection, which includes cleaning and a tuneup, costs $125 to $200.
Additional maintenance costs include filters and air duct cleanings. You need to replace the filters once every 90 days, which will cost $4 to $140 per year. Schedule duct cleanings every three to five years, and expect to spend $275 to $500 for the cost of cleaning air ducts.
Cost per Hour
Furnace repairs cost $50 to $150 per hour for the labor, plus you’ll need to budget for the cost of parts. Small repairs may be billed at a $100 to $200 minimum rather than by the hour.
One of the quickest repairs is to replace a dirty filter, which only takes a few minutes and is easy to DIY. Some of the more difficult, time-consuming parts to repair include the blower motor, the draft inducer motor, coils, and the heat exchanger.
HVAC Pro Costs
Hiring an HVAC pro in Detroit is going to be a bit more affordable than it would be in most other cities because the cost of living is a little below the national average. Still, labor accounts for 40% to 90% of your total furnace repair costs, or an average of between $112 and $250. For more time-intensive projects, like replacing motors, labor costs could double or triple.
Detroit requires permits for many furnace repairs, so you’ll need to budget for permit fees, too. You’ll have to pay a $75 application fee, and in most cases, you’ll also pay a $30 fee specifically for repairs to gas furnaces, bringing the total to $105. If you have damage to your heat exchanger, in particular, you’ll pay an additional $30 for a permit to service that component.
Finally, you should account for sales tax for the most accurate price possible. The sales tax rate in Detroit is 6%, which means a total of $16.92 in sales tax for the average furnace repair.
HVACs are one of the most complicated and essential systems in our homes. To avoid further damage or safety risks, always hire a certified HVAC specialist to repair or replace broken parts.
Do Furnace Repairs Increase Home Value?
Furnace repairs won’t increase your home value, but they can help avoid a decrease in property value. Especially in areas with colder climates like Detroit, buyers will expect the heating equipment to be in good condition. They’ll often offer less if they know they’ll need to service or replace the existing furnace shortly after closing.
You could bump up your home value, though, if you find you need a furnace replacement instead of a repair. Replacing your furnace provides an average return on investment (ROI) of 30%, so your property value could go up by several thousand dollars if you end up replacing yours. If that’s the case, you can maximize your ROI by choosing a high-efficiency heat pump, which more and more homeowners in Detroit are turning to for decreased heating costs.
How Angi Gets Its Cost Data
Home is the most important place on earth, which is why Angi has helped more than 150 million homeowners transform their houses into homes they adore. To help homeowners with their next project, Angi provides readers with the most accurate cost data and upholds strict editorial standards. We survey real Angi customers about their project costs to develop the pricing data you see, so you can make the best decisions for you and your home. We pair this data with research from reputable sources, including the U.S. Bureau of Labor Statistics, academic journals, market studies, and interviews with industry experts—all to ensure our prices reflect real-world projects.
Want to help us improve our cost data? Send us a recent project quote to [email protected]. Quotes and personal information will not be shared publicly.





- Furnace Repair
- Air Conditioning Repair
- HVAC Repairs
- Furnace Installation
- Wood & Pellet Stove Repair
- Dehumidifier & Humidifier Repair
- Heat Pump Companies
- Swamp Cooler Repair
- Wood Stove Services
- HVAC Companies
- Commercial A/C Repair
- Geothermal Installation
- Air Conditioning Installation
- Boiler Repair
- 24 Hour Furnace Repair
- Geothermal Repair
- Heat Pump Repair
- Humidifier Installation
- Thermostat Repair
- Thermostat Installation
- Nest Installation
- Heating & Cooling
- Heating Repair
- Furnace Cleaning
- Furnace Tune-Up
- HVAC Technicians
- Subcontractors
- Furnace Maintenance
- Plumbing & Heating Companies
- Wood Stove Inspection
- Mini Split Installation
- Wall Heater Repair
- Duct Installers