Top-rated stone and gravel pros.

Get matched with top stone and gravel pros in Schurz, NV

Enter your zip and get matched with up to 5 pros

Need a pro for your stone and gravel service project in Schurz, NV?

Select your specific project to find the pro for you.

Find Stone and gravel pros in Schurz

No results for Stone and gravel pro in

Try adjusting your search criteria.
Stone and Gravel questions, answered by experts

You should generally drill into the mortar joints when installing shutters on brick. Mortar is softer, which makes drilling easier and puts less strain on your tools. It also lowers the risk of cracking a brick—something that’s a lot harder to fix. Mortar holds fasteners well enough for standard shutters, and if you ever need to patch the holes later, it’s a much simpler job than dealing with damaged brick. Just keep in mind that if your mortar joints are too thin or the hardware calls for brick anchoring, you'll need to check the manufacturer’s recommendations and adjust accordingly.

Brick spalling—which refers to the crumbly, flaky, or pitted appearance that can develop over time—is caused by a few different conditions. These include:

  • Climates with constant freeze-thaw cycles

  • Use of non-breathable sealants

  • High-pressure water cleaning

  • Improper installation

While you can’t do anything about the weather, you can preserve your bricks by cleaning them with soapy water and a good old-fashioned scrubbing. Pressure washers may be satisfying to use, but they can eventually wear away the surface of your bricks. If you don’t have advanced-level DIY skills in masonry, you can hire a reputable masonry contractor in your area for your project.

Painted exterior brick does not usually need sealing. Brick is a porous material, so you don’t want to apply a sealant that could trap moisture inside the bricks and cause erosion and structural damage. The risk of moisture-induced damage after sealing is higher in colder climates where trapped moisture can expand if it freezes. On the other hand, it makes sense to seal really old brick or kitchen backsplashes, where moisture from cooking can weaken the brick.

The best way to clean creosote from brick is to hire a professional chimney sweep. However, you can use a creosote log to remove excess buildup between cleanings. You can also clean minor creosote buildup using dish soap or vinegar mixed with water.

Use fire bricks for a brick pizza oven. These bricks are typically used for fireplaces and chimneys as they can withstand high temperatures from heat sources. If you attempt to use any other kind of bricks, it’s likely that this material will crack from such high heat exposure in the best case—and potentially explode and cause serious harm in the worst case.

The Schurz, NV homeowners’ guide to stone and gravel services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles