Get matched with top animal fencing pros in Hampton, NE

In most cases, you will need a building permit to put up a vinyl fence, especially if the fence is sitting on or close to your property line. You can ask your local building department or  fence installation company if your fence project will require a permit. If so, you can expect it to cost between $20 and $60. Your fence installer should pull the permit for you. Building without a permit could eventually require you to pay again to remove the fence and reinstall it after getting the job approved.

Do you need a permit to build a fence if you are simply replacing an existing fence? Whether you need a permit in this case depends on your local laws and regulations. Most municipalities consider a fence replacement project as being equal to building a new fence, so you likely will need a permit. Check with your local building inspection department or zoning department to see if you need a permit. If you hire a local fence contractor, this pro can take care of obtaining all permits for you.

Most people prefer to keep the fence level by “stepping” the fence when running a horizontal fence over a slope. Stepping involves raising each panel between the posts as the fence moves over changes in slope, giving the fence line the appearance of stair steps. While this may be the preferred method of running a horizontal fence up a slope, there’s nothing wrong with installing your fence so it follows the undulations in the ground instead.

You can use pressure-treated wood for a horizontal fence, but you’ll need to purchase a thicker and higher-quality variety to ensure it doesn’t sag or warp after you install it. Use #2 pine grade lumber and boards and thicker dimensional lumber, such as a two-by-six. You’ll also need to use stainless steel or hot-dipped galvanized fasteners, as the chemicals in the treated lumber will cause regular galvanized fasteners to rust.