Get matched with top chimney inspectors in Rosebud, MO

Unfortunately, there’s no definitive answer to this question, but the wind rating of your shingles will give you a good idea of what wind speeds can damage your roof. If you’re concerned about damage, inspect your roof following windy conditions to look for signs of wind damage to your shingles. When in doubt, consider hiring a professional who fixes roofs to carry out an expert inspection. Remember that hurricanes, tropical storms, and tornadoes are likely to cause the most damage, but even severe thunderstorms can bring winds that compromise your roofing system.

While you can technically install new roof sheathing over an old layer, it is generally not recommended for several reasons. Installing new sheathing over old can trap moisture, which may lead to future problems, especially in humid climates. It also adds significant weight to the roof structure and prevents you from inspecting the original sheathing for rot, mold, or other damage.

However, in some cases, if the old sheathing has been thoroughly inspected and is in excellent condition with no signs of rotting, warping, or damage, a roofer may install new sheathing over it to add strength and stability. Despite this, the more common and recommended practice is to remove the old roof sheathing entirely before installing a new layer, as removing it is not a difficult task.

You should not clean roof shingles if the roof has damage like missing shingles or low spots where water may accumulate. You should focus on repairing the roof before any cleaning process occurs. If you notice roof damage as you’re climbing on the roof to clean it, stop immediately. Call a roofing pro to make repairs. Cleaning a roof that has damage could lead to pooling water or water damage to the roof decking. The roof cleaning process removes mold and mildew, making the roof look better. It is not going to fix physical damage, though.

A roof's ability to handle snow depends on its strength and the snow's weight, as wet snow is much heavier than dry, fluffy snow. While designs in snowy regions often allow for 35 to 50 pounds per square foot, a general guideline is that a typical roof can withstand about four feet of fresh snow, two feet of packed snow, or just one inch of ice. Factors like the roof's age, slope, and support structure also affect its capacity; newer, sloped roofs generally hold more weight than older, flat ones. Ice and ice dams add significant, dangerous weight. Because capacity varies, it is best to contact a professional roofing contractor or the original builder to determine the maximum snow load for your specific home.