Top-rated gas log pros.

Get matched with top gas log pros in Fort Ripley, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your gas log service project in Fort Ripley, MN?

Select your specific project to find the pro for you.

Find Gas log pros in Fort Ripley

Gas Logs questions, answered by experts

Yes. There are a variety of standard pipe sizes used in plumbing. The main supply line connecting your home to the street is either 3/4 or 1 inch in diameter. Supply lines are 3/4 inch in diameter. Individual components are 1/2 inch in diameter. Meanwhile, your main drainpipe is often 4 inches wide. Most shower and bathtub drains are 2 inches in diameter, most toilet drains are 3 inches in diameter, and most sink drainpipes are 1 1/4 or 1 ½ inches in diameter.

Call 811 to locate and mark the gas lines at least three days before digging. In many areas, you can dig within 18 inches of the lines, though in some locations, the distance may be further. Check local regulations, as you may need a utility company representative onsite when digging. Document your calls to 811 and precautions taken to avoid gas lines. A homeowner can be held liable for hitting a gas line in some cases, but contacting the proper authorities and following all guidelines can offer protection.

The easiest way to empty a propane tank is to simply use it until no propane remains. If you’re short on time and need a faster solution, transfer the propane to another tank instead. Wear leather gloves to protect your hands, then connect the hoses from both propane tanks and seal them tightly. Turn the knob to open the supply tank valve on the full tank and let it run until the pressure pushes all the propane into the other tank. When all propane is transferred, remove the hose and seal each tank. 

Although a gas company supplies gas to homes, connecting gas appliances, like a dryer, is not their responsibility. The primary role of a gas company is to safely deliver gas to a property and maintain the gas supply lines up to a specific point, typically the gas meter or shut off valve. The task of installation is usually taken on by the homeowner or professional dryer installer. 

DIY installation is not recommended due to the complexities of gas line work and venting; professional installation ensures safety and compliance.

The homeowners guide to home care is here

From average costs to expert advice, get all the answers you need to get your job done.