LOCH RAVEN REMODELING & HOME IMPROVEMENT

The carpentry and brickwork were superb and the end result is a great addition to the house. Job site was kept clean and all materials removed once the job was completed.

I had a large 42 inch wide cupola made of PVC that was very heavy that needed to be installed on a roof with a very steep pitch. The cupola came in 3 pieces - base, middle section, and top. The first phase required tracing the pitch of the roof onto the base unit and cutting the "V" for the unit to sit on the roof. The contractor was very careful to support the piece very well so that it would not break as PVC can crack very easily. The base was pushed up some ladders by three men, placed into position, and screwed into 2X4's for support.
The next phase required the middle section to be pushed up the ladders and mounted on the top of the base. This was a very heavy piece (possibly 85 pounds) and the three guys Carefully placed it upon the base and attached it with screws. The final phase required the installation of the weathervane hardware into the top section, pushing it up onto the roof and mounting it on top. This was very risky as the top probably weighed 50 pounds and the men had to lift it to shoulder height to fit.
The owner of the company, Geno, was one of the men doing the work and was extremely careful and conscientious about being safe and not possibly damaging the unit. The job took about 3 hours from start to finish and turned out perfectly.