Get matched with top siding pros in West Park, FL

Steel and aluminum are two types of metal siding that are commonly used for residential and commercial buildings, but the materials have specific differences. Typically, steel is heavier and sturdier, fending off scratches and dents, while aluminum is lightweight and more prone to damage. Cost is another differentiating factor, as steel is more expensive than aluminum siding cost.

There should be small gaps between your roof and the walls of your home, and other buildings. These small gaps let building materials shift, expand, and contract with weather and other outside forces, and they prevent moisture from wicking down walls from roofing and gutter systems. Without these strategic gaps, your home’s exterior and its finishes can sustain water damage, decay, peel, delaminate, and crack. However, there is a fine line between a smart gap and a problematic gap—all  gaps should be small, intentional, and covered or filled in with foam insulation to prevent pests from using them as access points.

You can calculate the required square footage of siding you need by measuring the height and width of your home’s rectangular exterior walls. For the triangular-shaped gable walls, measure the height from the ground to the tallest gable point to make sure you have enough for good coverage. Once you have combined the totals for each wall, add another 10% to account for wasted materials. It’s also good to have extra siding on hand to tackle wood siding repair down the road.

You should plan to stain or refinish your home's cedar siding every three to seven years to maintain its appearance and provide maximum protection, though some estimates suggest a range of four to six years. The exact frequency depends on several factors, including your local climate, exposure to severe weather like direct sunlight, rain, and wind, the quality of the initial stain application, the type of stain used, and the overall condition and quality of the wood.

For homes in harsh climates with high humidity and significant sun exposure, you should plan on staining as often as every three years, while those in milder locations may only need to do so every seven years. For the longest-lasting protection in particularly harsh climates, consider using an opaque stain.

If you are looking for a lower-maintenance alternative, you might consider vinyl or aluminum siding. While the initial installation cost can be higher, they do not require as much upkeep and can offer more value over time, especially in areas with excessive rainfall or high humidity.