Top-rated well and pump technicians.

Best well and pump technicians near Fowler, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Fowler, CO?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Fowler - Updated Nov 2026

Avatar for Ojo Springs Drilling & Well Service, Inc.
Ojo Springs Drilling & Well Service, Inc.
5.0(
2
)
Well Pump - Install or Replace

Serving Fowler, CO and surrounding areas

In business since 2001

Free estimates

Credit card accepted

Ojo Springs Drilling & Well Service inc is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers interests, and make their concerns the basis of our business.

Response time4 days
Recommended by100%of homeowners
Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Fowler, CO and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
A Plus Plumbing And Heating LLC
4.0(
4
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Fowler, CO and surrounding areas

In business since 2015

Free estimates

Emergency services offered

"Went well as could be expected, needed a part and ordered, when part came in found out we needed another part which delayed fixing our heat for almost a week in total, but having a carrier unit and not having parts in town is what made it difficult, not A+ plumbing and heating. I will be hiring for all future plumbing and heating work!"
Recommended by75%of homeowners
Wells and Pumps FAQs, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Several warning signs can indicate current or future issues with your well pressure tank. If you notice inconsistent water pressure, water spitting from your faucets, clicking sounds, or electricity bill spikes without other obvious causes, it may be time to get your pressure tank and well system looked at by a professional.

Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.

Ensures safe and effective service, restoring water flow and system efficiency.

Unfortunately, yes. If your well pump continues working when the flow of water is completely blocked, the motor will burn up. The energy has nowhere to go, thanks to the blockage, so it turns inward. The end result? A ruined well pump and a depleted bank account (once you shop for a replacement.) 

The Fowler, CO homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.